LISEN Magnetic Phone Holder for Car Upgraded Clip Ultra Car Phone Holder 6 Strong Magnets Cell Phone Holder Car Magnetic Case Friendly Phone Car Holder Mount for 4-6.7 inch Smartphones (Black)

Stable and Easy to Use Car Clip
I purchased this for my car to hold my phone up by air vents, and I love it!It is easy to install but once secured it holds very stable. I have added the magnet and have a cover on top of it and it still sits very stable when in use. It has been working so well that we purchased a second one for my husband’s car. Highly recommend.We have had it for a couple of months now, and it is still holding up very well.

Magnet works well. Vent clip could use some improvement.
I bought this because the previous cellphone holder that I had partially blocked the charging port on my phone. My phone is kind of old and I have to stay on top of the battery to make it through the day, so charging it on my way to/from work or on long trips is essential.This mounts by hooking onto one of the slats in the dashboard vent. The hook is then retracted until it captures the slat tightly. This is not a problem with vents that have slats of the same depth, but the vent on my dashboard is curved. This tends to skew the holder upward as it is tightened. I had to try a few times until I could get it to hold securely and not slip out of position. This puts a lot of pressure on a single vent slat, and we’ll see if the holder and/or the slat decide to break over time.The magnetic mount is nice because it leaves the entire perimeter of the phone unblocked, but you need to have a case with steel in it for the magnet to attract. My phone case doesn’t so I had to bond one of the included steel plates to the back of it.I initially tried to slip the steel plate between the phone and case (something the instructions tell you NOT to do, to be fair) but the distance between the magnet and plate is too large to keep the phone in place.My case doesn’t have a flat back, and I was afraid that the self-adhesive steel plate would not bond well so I used 3M high-bond double sided tape to adhere the plate to the outside of my phone case. This is VERY secure– I’m pretty sure I’d bend the plate before it ripped off the back of the case– but it makes the plate stick up from the back of the case by 1/8″. As a result it snags on other stuff in my pocket and it has a hard time fitting in the phone holder on my motorcycle.Note that this is not the fault of the holder AT ALL– it’s merely an experiment on my part that didn’t work. In the future I’ll probably switch to a magnetic case for my phone, IE one that has a steel stand on the back. That will be a cleaner solution than the hodge-podge that I have on there now. Keep that in mind if you have a phone case where it will be difficult to adhere a steel plate.I used the holder for the first time this morning. I can tell you that the magnet GRABS ON FOR DEAR LIFE. I stuck my phone onto it and drove to work, and my phone didn’t budge a bit. I’m really impressed with the strength of the magnet.So far I like this holder, and I’ll like it even more when I get a new phone case. I’m a little leery of how it clips onto the vent, and time will tell how durable that installation is. For the moment however, this holder is working very well and holds my phone quite securely.

What You See Is What You Get
..and that’s pretty darn good!! Excellent product. it was easy to get put in and it is pretty strong. Never budged once installed. The only down side is that you have to have the big magnet on the back of your phone cover..

Solid Phone Holder
The LISEN Phone Holder is a great addition to my car setup. Here’s what I like about it:Strong Magnets: The strong magnet securely holds my phone in place, even on bumpy roads. I never worry about my phone slipping or falling while I’m driving.Upgraded Clip: The upgraded clip design is impressive. It attaches firmly to the car vent and stays put, providing a stable base for my phone.Case Friendly: This mount works perfectly with my phone case on, which is a big plus. I don’t have to remove my case every time I want to use the mount.Versatility: It’s compatible with all smartphones and tablets, making it a versatile option for various devices in my household.Ease of Use: The magnetic attachment makes it super easy to place and remove my phone with one hand, which is very convenient when I’m on the go.The only reason I’m giving it four stars instead of five is that the vent clip can sometimes be a bit tricky to position just right, depending on the design of the car vents. Once you get it in place, though, it works wonderfully.Overall, the LISEN Phone Holder is a reliable and practical choice for keeping my phone secure and accessible while driving. I highly recommend it for anyone looking for a strong, case-friendly magnetic mount.

Very useful

افضل حامل جوال على الإطلاق أنصح بشراه